Taranto Seaplane Base
The intervention falls within the GREECE-ITALY 2014/2020 Program – SWAN PROJECT “Enhancing Regional Transportation Through Sustainable Water Aerodrome Network” for the construction of permanent hydrosurfaces for seaplane connections between the ports of Puglia and Greece. The planned intervention in the area called Calata 1 of the Port of Taranto involves the construction of a small passenger […]
Napoli Capodichino – Modernization and Upgrade of the Air Side Infrastructures
The scope of the work was the rehabilitation of the pavement of the Taxiway TS between the Taxiway D and the Taxiway E. The starting point for the design was the study of the Pavement Management System and the results of a campaign surveys consisting of: -coring; -DCP test; -particle size analysis; -plate load test; […]
Aosta – Air Side Facilities Enhancement
The Aosta airport (LIMW), located at 1,850 ft and surrounded by high mountains, was inaugurated in 1959. It was a private strip serving to national sport aviation. In 1987, airfield facilities underwent some improvements addressed to handle commercial aviation. Albeit this first leap the “Corrado Gex” Aosta airport was still suffering two main limitations: daily […]
Lamezia Terme – Enhancement Air Side Facilities
Lamezia Terme International Airport (ICAO: LICA), active since 1976, is located in the southern part of Italy. It handled 2.2 million passengers in 2013. Lamezia airport is connected with scheduled flights to the main Italian airports and to many international airports. Noteworthy is the high volume of charter activity which intensifies during the summer. In […]
Bari – Runway Extension and AGL Enhancement
Bari Palese “Karol Wojtyla” Airport (IATA code: BRI, ICAO code: LIBD) is an airport serving the city of Bari in southern east part of Italy. The airport handled 3,7 million passengers in 2014. Runway extension The works consisted in the extension of about 560 m of the runway 07/25, to reach a 3.000 m length and 45 m width, whilst simultaneously […]
Roma Caserma Macao – Helipad AGL System
Roma Caserma Macao, Castro Pretorio Barracks complex This assignment concerned the final and detail design of the systems and related civil works for the ICAO-compliant construction of an AGL (Aeronautical Ground Light) system necessary to ensure the operation in night flight conditions of the helicopter pad inside the “Helicopter landing area” of the Macao Barracks […]
Tripoli – Airport Developement, New Parallel RWY 09R/27L and TXW’s
Tripoli Airport (HLLT) Lybia The specialist support on writing the technical offer for tender based on the project plans which shows the main intervention relates to the following infrastructures: new parallel runway 09R/27L; new parallel taxiway “V” over the whole runway length; four threshold taxiways crossing with existing runway 09/27; four rapid exit taxiways; all […]
Aosta Airport – New Passenger Terminal
Aosta “Corrado Gex” Airporto (LIMW) After the design for Perugia Passenger Terminal, Gae Aulenti and TE2C won the tender for the design of Aosta passenger terminal, a regional airport in the extreme north of Italy, close to Monte Bianco (Mont Blanc, in the Alps). For this design too, Gae Aulenti developed, the idea for an […]
Ethiopia – Concept Design for 7 Airports
Ethiopian Airports The project, sponsored by the Ethiopian Airports – Ethiopian Airlines Group – envisages the construction of brand new passenger Terminals at the Jinka, Kombolcha, Robe Gode, Nekemte and Dembidolo airports. The current existing main infrastructures are not responding to the actual international level of efficiency, security, environmental and social aspect required for regional […]
Napoli – Land Side Arrivals Hall Extension
Aeroporto di Napoli Capodichino “Ugo Niutta” (ICAO: LIRN) The expansion of the Land Side Arrivals Hall at the Naples International Airport, contained in the 2013-2023 Airport Development Plan, was scheduled as part of the “2016-2019 Four-Year Intervention Plan”, intervention “A09 / Land Side Arrivals Extension ”. The intervention, by enhancing and optimizing spaces and functions, […]
Prague-Ruzyně Airport – Techno–economic study for the RWY 06/24
The assignment concerned the Technical-Economic study for the refurbishment and improvement of the pavement of Runway 06/24 of the Prague-Ruzyně airport (ICAO: LKPR) (Czech Republic). It was accomplished via the following steps: COST ASSESSMENT – Existing infrastructure Overview and Analysis – Runway Inspection – Subgrade Analysis – Traffic Mix Simulation CONSTRUCTION PHASIS ACN/PCN EVALUATION
Milano Linate – New Control Tower
Milano Linate Airport (ICAO: LIML) The volume of the TWR is characterized by the double-inclined glass enclosure (0°and 10°) for the VCR and S-VCR top operating floors. The plant floor, below them, is instead characterized by a closure in panels of metal slats that allow permanent ventilation of the premises. The stem, in reinforced […]
Kufra – Airport Development and New AGL System CAT I/II
Kufra Airport (HLKF) (Libia) Kufra airport, ICAO code HLKF e IATA code AKF, is located at the edge of the town named Al Jawf, Kufra Province, in the south-eastern state of Libya, Cyrenaica, about 1000Km far from the capital Benghazi. ARP coordinates are: N 2410.37 ; E 2318.55 The Preliminary Design identified a framework of […]
Dashoguz – AGL and Instrumental Flight Procedures
Dashoguz Airport, Turkmenistan (ICAO: UTAT) Dashoguz Airport presents a 3800 mt. long runway, equipped with two precision approach category II and III lighting systems for both directions. All of the runway, taxiways and links have a rigid pavement with concrete slabs. The main tasks concerned: -Design of primary and secondary cable ducts for AGL systems; -Design of transformer stations and electric board; […]
Volterra – New HEMS Helipad
The site on which the construction of this helipad is planned, falls in the south-west area of the Municipality of Volterra, in the province of Pisa, near Piazza Ginori and in front of the building of the former railway station, adjacent to a large car park near the bus and tourist bus terminal serving the […]
Alessandria – New Helipads and “C.O.E. 118” center
The project focused on the realization of a 118 Medical Emergency Operations Center at the service of the hospital of Alessandria, National Hospital “Santi Antonio e Biagio and Cesare Arrigo”. The Operations Center is equipped with the following facilities: helipad for helicopter take-off and landing and parking area; building used as an emergency operations center […]
Verona Airport – New Fire Station
Villafranca “Valerio Catullo” (ICAO: LIPX) The architectural, engineering and structural project is related to the realization of the following works: 1. a new building to be used as a garage and fire department for the airport fire brigade/new fire station; 2. a square in front of the garage; 3. vehicle entrance and operator parking; 4. […]
Venezia – Enhancement Air Side Facilities
Venezia Tessera “Marco Polo” Airport, Italy (ICAO: LIPZ) Venice – Tessera “Marco Polo” International Airport (IATA code: VCA, ICAO code: LIPZ) is located 8 km north of Venice in Tessera city. Due to the importance of Venice as a leisure destination it features flights to several European metropolitan areas as well as some seasonal long-haul routes. With 8,475,188 passengers […]
Treviso – Modernization and Upgrade of the Infrastructure of Flight
Treviso Sant’Angelo “Antonio Canova” (LIPH) Treviso “Antonio Canova” Airport (IATA code: TSF, ICAO code: LIPH) is located close to the worldwide known city of Venice, north east side of Italy. The airport is mainly devoted to host regional flights, low cost scheduled, charter passengers as well as mail freight and parcel flights. A total of 2.3 million passengers have […]
Trapani – Airport Masterplan
Trapani Birgi Airport “Vincenzo Florio” (ICAO: LICT) The Temporary Experts Grouping, composed of PricewaterhouseCoopers Advisory S.p.A. and Tecno Engineering 2C S.r.l., was commissioned by Airgest S.p.A. in preparing the Financial plan, the Airport Master Plan and the Planning applications, as well as provide the support required to obtain the total management of the Airport. During […]
Salerno – Implementetion of the Works Provided for the Development of the Airport
Salerno Pontecagnano “Costa d’Amalfi” (LIRI) Salerno Costa D’Amalfi Airport (IATA code: QSR, ICAO code: LIRI) is located 15km far from Salerno City in direction south east . Scope of the work assigned to TE2C was to upgrade existing AIRSIDE infrastructures and facilities to improve airport operations. Detailed design concerned the following items: rehabilitation and upgrade of runway paved surface. […]
Roma Urbe – Multifunctional Building
Roma Urbe Airport (ICAO: LIRU) Rome Urbe is the third main airport of Rome, mainly used for private air traffic and for flight school and heliport functions. Since the early 2000s, ENAC has commissioned several works to upgrade the airport. It currently offers a complementary service to the other two main city airports. The work, […]
Pisa – Infrastructure Upgrade, AGL CAT II / III Implementation
Pisa S. Giusto Airport “Galileo Galilei” (LIRP) Pisa “G. Galilei” International Airport (IATA code: PSA, ICAO code: LIRP), is an airport located in Pisa, Italy. It is the main airport in Tuscany. It is named after Galileo Galilei, the famous scientist and native of Pisa. In 2014, slightly approaching the threshold of 4,7 million of passengers handled, Pisa International Airport ranked 8th for […]
Perugia – Passenger Terminal Enhancement
Sant’Egidio “Adamo Giulietti” (LIRZ) Perugia Passenger Terminal was the result of collaboration between the Italian architect Gae Aulenti and TE2C. Gae Aulenti, one of the best known Italian architects in the world, after a huge number of projects in Italy and abroad, designed her first passenger terminal in Perugia. The project is inspired by the […]
Palermo – Passenger Terminal Enhancement
Palermo Punta Raisi “Falcone e Borsellino” (ICAO: LICJ) The Preliminary Project on the basis of which this Final Project was drawn up, refers to the “New Scenario 2020” relating to the reconsideration, which took place in 2014, of the planning documents that GES.A.P. had submitted when defining the ENAC-GES.A.P. together with the related Plan and […]
Olbia – Airport Masterplan
Olbia Airport “Costa Smeralda” (ICAO: LIEO) Olbia Costa Smeralda Airport ( IATA code : OLB ; ICAO code : LIEO ) is one of three major international aviation airports of Sardinia (the second island in the Mediterranean by extension). The Airport Masterplan has been prepared on behalf of GE.A.SAR . S.p.A. to implement strategies and […]
Napoli Airport – New Retail Area
Capodichino “Ugo Niutta” (ICAO: LIRN) Napoli Capodichino Airport, one of the most important airports in southern Italy, has been enlarged, renewed and enhanced in all its parts in the last ten years. This renovation project is still running today, with an extension of the arrivals area on the south west side, on which TE2C is […]
Lampedusa – New Passenger Terminal
Aeroporto di Lampedusa (ICAO: LICD) The Lampedusa airport is located on a small island and is the southernmost part of the Italian border (nearer to the African coast than the Italian one) and is used for connections with Sicily and for tourism. The task was to design a small airport with a low budget (located […]
Lamezia Terme – New Passenger Terminal Project
“S. Eufemia” (ICAO: LICA) The design for this new passenger terminal represented a truly interesting challenge in terms of design complexity and site construction planning. Sant’Eufemia Airport (IATA code: SUF, ICAO code: LICA) is an airport serving the city of Lamezia Terme in the south western part of Italy. In 2014, the airport handled 2.4 […]
Elba – Enhancement Air Side facilities
Marina di Campo (ICAO: LIRJ) Elba Island “Teseo Tesei” Airport (ICAO code: LIRJ) located in the area of Marina di Campo is a civil airport serving the Elba Island in Tuscany Region. The airport It’s open both to the commercial and general aviation aircraft but the scheduled flight are only in summer season. The airport handled 17,009 […]
Cuneo Airport – Terminal refurbishment and enhancement
Cuneo Levaldigi “Torino Olimpica” (ICAO: LIMZ) Cuneo’s passenger terminal needed deep refurbishment and enhancement after a violent fire destroyed part of the old building, including the control tower situated on the rooftop. The project consisted of the demolition of the damaged parts of the building, the construction of two new wings (on the right and […]
Comiso – Pio La Torre Airport – “Aeroporto degli Iblei”
Comiso Airport “Pio La Torre” – “Aeroporto degli Iblei” (ICAO: LICB) The Comiso Airport project comprises the complete design of a new civil airport involving both airside and landside. This project allowed for a NATO nuclear missile base to be converted into an airport after the end of the cold war. Regular commercial flights, both […]
Bologna – Passenger Terminal Enhanement
Bologna “Guglielmo Marconi” Airport (LIPE) The expansion of the Bologna Airport Passenger Terminal, necessary both in relation to the trend of air traffic recorded in recent years (8,181,654 passengers in 2017 with an increase of 39% in the last five years) and to forecast of evolution of passenger demand in the short and medium term, […]